chrysler Workshop Repair Guides

Chrysler Workshop Service and Repair Manuals

Fluid Filter - A/T > < Emissions - MIL ON/DTC P0440/P0457
Page 2
background image

REPAIR PROCEDURE:

1.

The filter is mounted on the outside of the frame rail behind the left rear tire. Remove the wire harness retainer form the stud in front of the vent
filter mount.

2.

Remove the inlet and outlet hose, remove retainer nut and ESIM filter.

3.

Install the replacement ESIM vent filter, p/n 04891994AA and install retainer nut.

4.

Install the inlet and outlet hose.

5.

Replace the wire harness retainer on the stud in front of the filter mount.

6.

Was the ESIM Detector replaced as determined by the diagnosis performed above?

a.

Yes - proceed to Step # 8

b.

No - proceed to Step # 7

7.

Replace ESIM Detector, (located on vapor canister):

a.

Remove hose and electrical connector from ESIM.

b.

Push retainer tab and rotate ESIM housing to remove.

c.

Install new ESIM p/n 04891729AA reversing procedures above.

8.

Verify repair is complete and MIL is now off.

POLICY:
Reimbursable within the provisions of the warranty.

TIME ALLOWANCE:

FAILURE CODE:

Disclaimer:

This bulletin is supplied as technical information only and is not an authorization for repair.

Fluid Filter - A/T > < Emissions - MIL ON/DTC P0440/P0457